DIY Bedroom Love Sign

You will need to create your wall art:
Plaque:  I bought it at Hobby Lobby, but here are some great alternatives:
https://amzn.to/38ntSON
https://amzn.to/2SjbCAw
Love chip decor:  I found it at Hobby Lobby, but here is an alternative:
https://amzn.to/2Tr114x  
I and U alternative:  https://amzn.to/37gypBb
Rain grey:  https://amzn.to/31OzJu6
Drizzle gray:  https://amzn.to/2SlBLPm
Surfboard blue:  https://amzn.to/2SCmI2t
Matte finish:  https://amzn.to/2vqLnz8
Removable strips to hang:  
https://amzn.to/2SovBhv

Directions:

1.  I gathered the parts for my sign.  

I used the same love in last years heart art project, which you can find HERE.

2.  The first thing I did was distress the plaque.  I used an ice pick and a screwdriver.  You can also use a chisel and a hammer. 

To make things go a little quicker, I broke out my Dremel, but that is optional.

3.  I used two different grays and painted it on.  If it is too thick, you can water it down.  

4.  I then used a dry paper towel and wiped off any excess.  If you want to remove more, you can use a wet paper towel.

Keep going until you get the whole board covered, front and back.

5.  I took my “I” and my “U” and used my Dremel to soften the edges.  Just a little, nothing major.  You can use sandpaper too, or just leave it.

6.  I painted the “I” and “U” white.  Figure it will take multiple coats.

7.  I painted the love aqua…again multiple coats.

8.  I figured out my placement and then I thought about it and I liked the love by itself just as well.

9.  I put the removable strips on the back of all of the letters.

I went with the removable strips, so if I want to change the look, with different letter or even for the holidays, I can!

Be Sure to Share and PIN IT!