SUBSCRIBE to my YouTube Channel!
I have been asked to make a dandelion paperweight for several years. I never did it because, to be honest, I was a little intimidated. When asked again, I promised if I found a perfect dandelion, I would jump in and do it this year. Turns out, it’s remarkably easy!
The links below help support this channel, as I may earn a small commission at no extra cost to you.
You will need:
Ice molds: https://amzn.to/1tal0Hq
Resin (use whatever resin brand you like):
Easy Cast: https://amzn.to/2yjYmBC
Art Resin: https://amzn.to/2yk9X3z
Clear Cast: https://amzn.to/2z4rxGw
FX Poxy: https://amzn.to/2AF3Pkk ~ According to the manufacturer, this one is heat resistant to 500 degrees F and is UV resistant.Dandelions – you’ll have to go outside and pick your own
Easy Cast: https://amzn.to/2yjYmBC
Art Resin: https://amzn.to/2yk9X3z
Clear Cast: https://amzn.to/2z4rxGw
FX Poxy: https://amzn.to/2AF3Pkk ~ According to the manufacturer, this one is heat resistant to 500 degrees F and is UV resistant.Dandelions – you’ll have to go outside and pick your own
Here is the video tutorial:
Directions:
1. Mix three ounces of resin, according to the package directions.
2. Pour the resin into the molds. Let it sit for a few minutes and then take a lighter and pop the bubbles.
3. Take your dandelion puff and holding by the stem, slowly press it into the resin.
4. Take two popsicle sticks and use them to hold the stem straight.
5. Allow to cure.
6. Snip off the stems as close to the resin as possible.
7. Mix a little more resin and top it off, making sure the stems are embedded.
8. Allow to cure.
9. Once cured, unmold them.
That’s it! No you have a beautiful paperweight! And so easy!
Thanks for stopping by!
Remember: Life’s too short not to shimmer, so grab your glue gun and your glitter!™ Stay Safe!
Mona